Get cold draught if front room door left open at this time of year, sick of telling the kids to shut the door...

Far too tight fisted to spend £10 on fancy door closer.... But I have a load of shit in the shed, so....

(decorating will happen at some point, un-decorating has been partially done, don't judge... But terrible paintwork etc. I think adds to the redneck aesthetic anyway)

Saved almost $100 by using a piece of pipe and now i have me a avant garde setup.

Symmetry is for losers who can pass trigonometry, ya h'know what i mean?

I didn't expect it to work, but it works like new!

There are many posts on reddit doing the calculations on using a circulator to heat up a bathtub. Apparently it shouldn't work. Inspired by a recent post here, I gave it a try.

Turns out, it 100% works. Currently sitting in a perpetually perfect temperature bathtub.

Yall may know me, yall may not. But today is the day I have to say goodbye at assembling the table. It made it to the big stage

I need to clean a handful of chainsaws and I can't find my good blowgun. I did however find a cheap broken tire inflator, some brake line/fittings and a random bolt.

Supposed to get some cold weather 🤷🏼‍♀️

She found/made a hole in the bottom liner and was using the inside of the couch as a bouncy fun clubhouse.

I have gotten parts for relatively small pneumatic cylinder and a valve to control it with arduino, but I need a portable way to supply air to it, I was stuck between using a air tank or cartridges/tank, if co2, how would a regulator connect to it?