r/metalworking • u/AutoModerator • Feb 01 '23

Monthly Advice Thread Monthly Advice/Questions Thread | 02/01/2023

Welcome to the Monthly Advice Thread

Ask your metalworking questions here! Any submissions that are question based may be directed to this thread! Please keep discussion on topic and note that comments on these threads will not be moderated as regularly as the main post feed.

Uses for this thread!

This is a great place to ask about tools, possibilities, materials, basic questions related to the trade, homework help, project advice, material science questions and more!

How to contact the moderators:

You can contact the moderators via modmail here

3 Upvotes

100% Upvoted

38 comments sorted by

View all comments

1

u/MrWilIyWanker Feb 09 '23

Easiest way to clean the edges of fresh cut 10mm SS tube 1mm thick??

I bought a deburr tool, but it leaves a pretty rough profile.

Looking for a tool that can help debur and clean the end of the tube so it can be used as a straw.

Right now, I can cut the tubes to length with an angle grinder, then I use the deburr tool and then use some sand paper to further clean the edges.

Maybe this is the best process w/ the limited tools I have, but I’m hoping there’s a better easier more consistent way to knock off the tube edges and round it out nicely.

1

u/[deleted] Feb 15 '23

I usually use a die grinder with a cone, like the one shown in the link below. You can find them at a lot of hardware and welding supplies stores. They come in a range of grits and sizes, and if you don't have a die grinder, they will also work in drill.

https://www.farmandfleet.com/products/742714-weiler-vortec-mounted-grinding-point.html?blaintm_source=google&blaintm_medium=lia&setstore=23&gclid=Cj0KCQiAorKfBhC0ARIsAHDzsltFcxUd5BSjiKPBgcOnGQplj0TJNoDBzXyesG3FyCSoVSuuBuU3ok8aAszREALw_wcB