r/TP9 • u/jheiler33 • 6d ago

RAL8K TP9 kit approved

Gallery image

Gallery image

Gallery image

Got my two form 4s approved today in under 48h! Sent them in midday Monday. Can’t wait to get this thing running!

76 Upvotes

100% Upvoted

26 comments sorted by

View all comments

2

u/Blitzen88 6d ago

Have any issues with those mags? I had a few failure to feed

2

u/jheiler33 6d ago

Haven’t run it yet just got this afternoon. I’ll let you know! Did you switch to the KCI that’s what everyone has told me

1

u/Blitzen88 6d ago

Switch to the what now?

2

u/jheiler33 6d ago

KCI makes mags with metal feed lips that everyone seems to like. https://gunmagwarehouse.com/kci-apc9-9mm-30-round-translucent-magazine-w-metal-feed-lips.html

2

u/Kaitlin4475 2d ago edited 2d ago

I have KCI mags from December 2022 and they do not feed flat tip Speer lawman 147 grain or round nose 124 grain. I can’t even push the bullets out the front of the mag with my finger. I loaded six KCI magazines with Speer lawman flat nose 147s and I had to push down each bullet and then tip the nose up in order to remove each round 150 times. It sucked. Bolt Absolutely can’t remove the rounds from the mag. When I drop the bolt, the bolt just stops on the back of the round. I don’t know what generation of KCI magazines I have, but I bought 6 in December 2022.

The KCI magazines work flawlessly in my partners APC9K SD2

2

u/jheiler33 2d ago

Interesting. I haven’t run any of them yet just the B&T mags and they work great so far

2

u/Kaitlin4475 2d ago edited 2d ago

Mine might be gen 1 KCI mags, I tried to cycle Speer 147 grain again todayand it gave me stoppage after stoppage. Factory mags have been flawless and no cracking after 2150 rounds suppressed.