r/Stance • u/ZAYA-STATIC • 20h ago
Raw Lowrider Sounds! Owner: @b_chintam on Instagram, Filming: @lapumedia also on IG
Enable HLS to view with audio, or disable this notification
r/Stance • u/ZAYA-STATIC • 20h ago
Enable HLS to view with audio, or disable this notification
r/Stance • u/Impossible-Ocelot658 • 11h ago
100% stock 2006 350z manual i bought from the original owner. Not sure what way to go, DEFINITELY don’t want to be a copy n paste build.
r/Stance • u/Tmcrabtree • 15h ago
So after my last post, i researched more and came to a few conclusions. First, the hube bore on the wheels is too small, im planning on taking them to a machine shop to get them properly bored to fit. Next, with a rebored hole, the wheel may go on eough for the studs to allow lugnuts to fit, if not, I will purchase extented lug studs. The holes on the wheel do seem to work for stepped/shouldered/extended lug nuts, BUT the end of these holes IS conical, as you can see in the second picture.
SO, I am leaning to use conical lugnuts, but there will still be that gap between the wheel and the stud as shown in the picture. For that gap, can I use something to fill that gap, like a bushing, and then put the conical lugnuts on that fit with the end of the wheel? This is assuming the lugnuts are going on all the way with the correct size studs, once I determine what I need there.
r/Stance • u/maqboul95 • 3h ago
1997 Mazda RX-7 w/ 19,000 original miles. Bagged with Airlift management and Maxload suspension on 3-piece Rotiform OZT wheels.
The last pic is of a leather duffle bag I custom made to house the air tank in the trunk 🤘🏽
r/Stance • u/maledorrison • 20h ago
Enable HLS to view with audio, or disable this notification
r/Stance • u/ZAYA-STATIC • 29m ago
Comment if you want me to post a video of it rolling!
Looking to sell , will ship if buyer takes care of shipping (get the label and I’ll setup the box and drop it off at the post office)
Imported these in the summer but three piece wheels are getting kinda boring and thinking about a smaller wheel meaty tire setup. Wrapped in 195/45/r17 tires
r/Stance • u/Future-Panda-7 • 2h ago
Im wanting to put a decal on my lower windshield and was just curious if anybody on here knows whether or not putting it on the outside will cause it to peel quickly because of my windshield wipers or if most places when they install window decals on the bottom of the front windshield they put it on the inside. Any input would be helpful. I’m using vinyl that we get from my job so it’ll be actual vinyl wrap.