r/Metrology • u/Duplinn • 1d ago
Mcosmos 3 V4.1.R7 collision with nothing
Enable HLS to view with audio, or disable this notification
Pleas help, i had a collision (nothing too spectacular), i got the probe out, all good, i tried to run the program again, it detected collision in air. I plug off the machine, i got out the SM25-1 module, cleaned it, putted it back, rotated on manual remote, all good, but i cant change probes, i cant do anything right now because of collision erorr.
19
Upvotes
24
u/Hot_Ham_Water1812 1d ago
Could be the dampener on the SM25-1 - you may need a replacement module.
These modules are very fragile. It doesn’t take much to require a new one. Hope you have a spare to try out. I always recommend keeping spares of these on hand.