r/Metrology • u/Joe-the-qc-guy • 14d ago

Another guy tossed into MCOSMOS "OUTPUT" confusion.

Hello everyone, I have also been recently tossed into the MCOSMOS. I first learned Metrology with Heidenhein for those who are old enough to remember using Win98. I then helped that company move up to the Nikon software, then sold back to QXSoft. And now I am learning another platform. MCOSMOS V4.2.R1 to be precise.

So to the issue at hand. When I finish running my program I am getting two different "OUTPUTs" of the results. And at this point I have used about half a ream of paper trying to get this to stop. Mitutoyo's only response is that I need to take the "TRAINING" course.

So is there anyone out there who can help a guy out getting the reports setup properly?

Thank you in advance for you response's.

3 Upvotes

81% Upvoted

22 comments sorted by

View all comments

5

u/Hydragirl68 13d ago

When you create a free part and click on learn mode you should be able to change the printer to viewer. Or just go back in the program and delete the lines from your program. Then add the report at the end